About Us


Enterprising Engineers was established in 1972 by a team of qualified, experienced and enthusiastic engineers. With continued and dedicated efforts, Enterprising Engineers has now over 25 years of experience in designing and manufacturing MCC, PCC, electrical panels, stator rotor starters, marshalling boxes, switch boards etc. What started with a humble dream has today transformed into a highly successful and trusted name in the electrical industry. With our constant commitment and focus we are constantly setting new standards of quality, safety and performance.

Our biggest asset is our highly skilled and experienced team that works closely with our clients to understand their specific requirement and accordingly manufacture products exceeding their expectation level. We have an in house competent team of engineers that design the products and processes and same vision is than translated into highly efficient products by our expert technical team.

The end result is a range of high quality products that include electrical panels for MCCs, PCCs & Switch Board, M. Box & Customer specific Panels like Control Desks, Instrument Panel, Starter Panels, mechanical interlock systems, key exchange boxes etc that meets all the global regulation and safety parameters.

Quality Control
We have sophisticated Quality Control Department equipped with modern testing facility and backed up by qualified and experienced persons to ensure better quality products. We use only highest-grade raw material sourced from reliable vendors. Similarly all components used are of original make procured through authorized dealers or directly from the manufacturers.

Each component is inspected and tested by Q.C. department prior to use. Further stage inspections are carried out to ensure defect free product. And before final dispatch, rigorous testing of the panel is done to ensure adherence to specifications and avoid problems at site.

Welding is the only activity in our workshop where inspection at a later stage will not reveal its capabilities.

Quality procedure adopted for welding activity is: Most cases involve 3mm to 5mm thick. Mild Steel cold rolled and hot rolled. These are cut and bent in required shapes and are but welded lap welded to other sheet components, base frames support members like Channels or Angles to produce Cubicles, Boxes, Tanks etc. Member to be welded are prepared by cleaning along the joint and then tack welding to retain them in position. These are then continuously welding to produce a sound blowhole proof weld seam electrodes used are 2.5mm to 3mm Dia with rutile coating. These are stored in dry enclosure and taken out when needed for actual welding.




Looking for Product Name ?